WFCO Artis Water Pump Model # PDS3B-130-1260E
12 volt ONLY 110/115/220 volt such as in a house or generator will damage the unit
NSF Approved Materials
3.0 Amp Draw @ 0 PSI
7.0 Amp Draw @ 50 PSI
Open Flow 3.0 GPM
Shut Off 60 PSI
Inlet / Outlet ports ½ M-NPTS
MOTOR Permanent Magnet, totally sealed, enclosed ball bearing/ thermal protection.
SELF-PRIMING upto 9 feet
DRY RUN CAPABILITY
Corrosion Resistant Materials
Self-priming to 6 feet suction
FRESH WATER USE ONLY
STRAINER Includes a WFOC 30 mesh Strainer that must be used for warranty
PUMP MOUNTING Pump can be mounted horizontally or vertically (mount pump head down). Do NOT over-tighten screws.
PUMP CIRCUIT Pump should be on a dedicated (individual) circuit protected by the specified fuse on indicated on the motor label.
ON/OFF SWITCH Use a 10-15 amp rated on/off switch on the positive red motor lead wire.
FUSE Install a 10 Amp. max fuse in the line between the 12VDC power source and the ON/Off Switch.
WIRING Use 14-gauge standard wire up-to 20 feet or 12-gauge up to 50 feet from power source. Length is the distance from the 12VDC power source to the pump and back to ground.
WATER LINES Water Lines should be 1/2" I.D. (13mm) Flexible hose (preferably braided or reinforced) for main lines