Vortex I and Vortex II are fan inserts that are used to replace the fan or install a fan into a Standard 14" RV Roof Vent.

An RV Roof Vent is needed to place the insert into, vent and inner garnish ring is not included with the inserts.

Fits
Heng's 14" RV Roof Vents Manufactured after 2016, it may fit various models but end user will need to verify

Ventline 14" Standard RV Roof Vents Manufactured after 2016, it may fit various models but end user will need to verify

Rounded Corners are rounded on unit

Manual Crank Handle to open and close RV vent lid

Interior Garnish Ring is NOT included

Vortex I and Vortex II are 12 volt power only
If you are not aware of your power supply please consult a certified electrician before ordering/installing.

When installing a Vortex Fan do not let the unit hang by the wires, damage will occur to the switch.

Do not overturn knob, damage to knob will occur if too much force is used.

Some models of vents will need to move the manual crank handle box that is on the units backside, photo instructions are included below.

NOTE:  Vortex New Design has a pre-stamped cut-out for a fuse that is required in Canada. This is not a defect in the housing but the new design by the manufacturer.

Do Not allow unit to be exposed to rain, this will damage the circuit board and motor over time.




When installing a Vortex Fan do not let the unit hang by the wires, damage will occur to the switch.


1. Remove the handle from the vent.




 2. Remove the screen from the vent.



 3. Locate the cross bar in the lid of the vent, there will be tabs on both the top and bottom of the bar you will need to flatten these down.





 Be sure to flatten the bottom ones as well.



 4. Locate the gears for the fan, you will need to remove the screws on the front side of the fan for the gear box to move.



 

5. After the screws have been removed you will pull the gear box out and simply move it to the bottom hole.

Remember to replace your screws.






6. Line the gear box and crank gear up, the gears should fit together easily.



 7. Don't forget to secure your vent with the screws provided into the outer rim of the Vortex II




8. Last attach the handle.




Vortex Switch Only


Be sure to remove the set screw









Add Comment

TOP