Heng's and Ventline 14" RV Roof Vents Manufactured after 2016, it may fit various models but end user will need to verify.
DOES NOT fit Fantastic Brand
12 volt Fan Motor
9" Fan Blade
1.8 amps of power required
DO NOT let the unit hang by wires as you will damage the unit.
Multi Speed Fan
Some models of vents will need to move the manual crank handle box that is on the units backside, photo instructions are included on classacustoms blog
Do Not allow unit to be exposed to rain, this will damage the circuit board and motor over time.
NO Vent included, this is insert only
INSTALLATION - Step-by-Step Photos
If upgrading non-powered vent 18 Gauge Wire to 12 volt DC recommended
Testing Unit before installing you must have unit facing correct direction, face down like when installed in rv, or blade will rub
Remove garnish ring from existing roof vent and save screws for re-installation.
Remove crank handle, screen and fan unit from existing roof vent.
Do not let the Vortex unit hang by the wires, damage will occur to the switch.
Existing Ventline Vents: Unscrew and move gear drive to alternate position as shown on installation instructions
Existing Jensen Vents: Unscrew and move gear drive to alternate position as shown on installation instructions
Hold Vortex unit near ceiling and attach Vortex wires to RV 12 volt power wires
Do Not let the unit hang by wires as you will damage the unit
Secure Vortex unit onto existing vent frame, making certain the crank spindle is properly aligned and seated in the matching gear drive (if necessary use knob to rotate gears to achieve alignment)
Secure gear drive spindle with screw
Make sure wires are out of the way of the fan blade
Attach screen frame, inserting 4 tabs and rotating clockwise until tight
Attach manual crank knob with screw
Reinstall original garnish ring