1. Home
  2. 5th Wheel Landing Gear
  3. Rebuild Kits
  4. FOLLOW / IDLE 5th wheel Landing Gear Leg Rebuild Kit
FOLLOW / IDLE 5th wheel Landing Gear Leg Rebuild Kit
FOLLOW / IDLE 5th wheel Landing Gear Leg Rebuild Kit

FOLLOW / IDLE 5th wheel Landing Gear Leg Rebuild Kit

0 Review(s) Write a Review
Your Price: $36.99
Part Number: 045-146060
Availability: In Stock. 25 Free Shipping.

Free USPS Mail Shipping to the lower 48 Contiguous US Only

This rebuild kit is for repairing the idle / follow leg on 5th wheel landing gear

No retail box as these are purchased in bulk, no install instructions as they are OEM parts.

(1) Follow Drive Shaft - 4" Long x 1/2" diameter

(2) Drive Shaft Bushings

(1) E-Clip

(1) Drive Pin

(1) Spirol Pin

(1) 12T bevel Gear

(1) 16T Bevel Gear

(1) Shim Washer

(1) Thrust Washer

Before replacing any items please go through the following checklist

If your motor is making a clicking sound this is the safety clutch in the motor preventing damage to the motor.

This is not the gear box.

When clutch noise occurs, release the power switch.

Failure to do so will result in damage to motor and possibly other system components.

Check for binding

Your trailer legs should be cleaned and checked for debris on a regular basis. Sand and dirt will cause legs to bind.

To clean landing gear legs

Extend landing legs as far as possible, clean drop tube and inner ram tube. Coat exposed surface of tubes with silicone spray lubricant.

Coat inside of handle alignment tube with silicone spray lubricant.

Oil shaft bushing in gear box and leg gear heads with SAE 30 oil.

Lubricate gears in gear box and landing leg gear heads with extreme pressure grease.

*Do NOT open motor to lubricate as this voids warranty.

Check for damage to legs

Any damage to the legs such a bending or denting will cause binding.

Check power to system

Check that your batteries and power supplies are at full levels to prevent damage to the motor.

Check wiring connections at battery. Clean terminals with a solution of baking soda and water.

Cover with a thin coat of grease.

Check wiring harness fuse, if blown replace with appropriate fuse.

Do not exceed weight limit of landing gear system

Do not use the landings legs to lift the trailer during tire changes, axle work or trailer servicing (the trailer weight will exceed the capacity of the landing legs).

The landing legs are designed to stabilize a portion of the trailer’s weight.

Support the front end of the trailer with structural stands rated for the GVWR of the trailer.

Related Items

12 volt DC Replacement Range Hood Motor by Heng's
This item is currently out of stock and will ship when back in stock. Free Shipping.
WASTE TANK 28 Gallon Black Water Holding Tank
In Stock. Free Shipping.

Browse Similar Items