Membrane Ships Folded Depending on size of
kit you will get one or two boxes (glue / membrane)
Membrane
Length / Width It is recommended to get a length that is longer /
wider than your unit due to possible curve of the roof, raised or lowered
areas, removing the excess is much better than not having enough.
Kits 5 Foot Long Membrane and Adhesives
Membrane 8.5 foot wide x length selected
2 Tubes of Class A Customs
Self-Leveling Silicone Caulk (Color White 10.1 fl oz Tube)
2 Rolls of Putty Tape (1/8" Thick x 3/4" W x 30' L)
1 Gallon of Class A Customs Acrylic Water Based Adhesive
Kits from 10 Foot Long - 25 Foot Long Membrane and Adhesives
Membrane 8.5
foot wide x length selected
4 Tubes of Class A Customs Self-Leveling Silicone Caulk (Color White 10.1 fl oz
Tube)
2 Rolls of Putty Tape (1/8" Thick x 3/4" W x 30' L)
1 Gallon of Class A Customs Acrylic Water Based Adhesive
Kits from 30 Foot Long - 45 Foot Long Membrane and Adhesives
Membrane 8.5 foot wide x length selected
5 Tubes of Class A Customs Self-Leveling Silicone Caulk (Color White 10.1 fl oz
Tube)
4 Rolls of Putty Tape (1/8" Thick x 3/4" W x 30' L)
2 Gallon of Class A Customs Acrylic Water Based Adhesive
Installation Help
EPDM Membrane
EPDM roofing lasts 20 to 25 years and has been in use since the 1960's and has
been proven to last well on RV roofing applications, as well as being the
easiest roofing type to install.
40 MIL Thick Single-Ply Membrane More durable than double-ply membrane (rubber with black
bottom and white top)
Less likely to crack than other membrane types, however it absorbs
more heat than TPO and PVC roofing
Color White,
same throughout the entire surface.
Textured Surface
for better traction install with the textured size facing up and the smooth
side down toward the roof (facing glue) however the rubber may be installed
with the smooth side down if you wish.
Class A Customs Acrylic Water Based Adhesive
Water base adhesive designed for use as a bonding adhesive for single ply
roofing membranes.
Designed to Bond EPDM, PVC, and Hypalon to wood fiberboard, plywood, EPS, any
typical polyisocyanurate insulation, gypsum, concrete, etc.
May be applied by spray, roll coating, or by brush.
Grows stronger and adheres more with age.
Remains flexible to compensate for expansion and contraction of the membrane
itself.
COLOR White
COVERAGE 160-200 sq ft/gal (1side @ 8-10 mil)
May be applied by spray, roll coating, or by brush.
(When using spray application an Aro 650095 4.25 inch air motor with a 30:1
ratio pump @ 80 psi using a 651-500 gun equipped with #651551 quick clean and
spray tip #T.C. 1565 with 0.015 orifice or similar equipment is recommended).
For maximum bond strength a two-sided application is recommended.
If one surface is porous, such as plywood or fiberboard, it is acceptable to
wet laminate the membrane to the substrate.
If both surfaces are non-porous, such as EPS or ISO apply the adhesive to both
surfaces 4 - 5 mils and allow to dry approximately 20 - 30 minutes, depending
on conditions.
Adhesive will turn from white to clear when it is dry.
Apply membrane to roof deck and roll or broom down sheet to assure 100% contact
area.
DO NOT FREEZE - KEEP OUT OF REACH OF CHILDREN
Putty Tape
Non-hardening, pliable putty tape.
Color Gray
Waterproofs overlapping metal seams.
1/8" high X 3/4" wide - Roll 30 feet long
Class A Customs Self-Leveling Silicone Caulk (Color White 10.1 fl oz Tube)
All weather self-leveling sealant designed and formulated to provide excellent
weather resistance.
It features high solids, low V.O.C. content, and no hazardous air pollutants
(HAP).
This compound provides good adhesion to a variety of substrates.
This product has good low temperature resistance and will not crack at -40oF.
Typically used in RV applications where a long-term weather tight seal with
good ozone and UV resistance are required.
Cured sealant is paintable.
Surfaces should be free of dirt, oil, or other contaminants. A solvent cleaned
surface is optimum.
PRECAUTION ON ALL PRODUCTS
This material in the liquid or vapor phases is extremely flammable. Keep away
from sparks and open flame - do not smoke by this product.
Avoid prolonged breathing of vapors of this product - use in a well ventilated
area. Prolonged breathing of vapors may cause headaches and even
unconsciousness.
Direct contact of uncured sealant irritates eyes and may irritate skin. In case
of eye contact flush eyes with water for 15 minutes and call a physician. In
case of skin contact, thoroughly wash skin with soap and water.
Material may be harmful or fatal if swallowed. If swallowed, do not induce
vomiting. Seek medical attention immediately.
Warning: Cancer and reproductive harm. www.P65Warnings.ca.gov.
Installation Help
