BLACK TANK Used for Human Waste or Gray Water - DO NOT USE FOR FRESH/DRINKING WATER

MADE WITH Medium Density Polyethylene (MDPE) Resin

SEAMLESS One piece seamless construction, no seams to burst

RESISTANT Stain, Corrosion and Rust Resistant

INSTALLATION & PLUMBING
Do Not over-tighten fittings damage will occur
3” PVC Female Pipe

MOUNTING & BRACING
Brace tank to prevent tank from moving during transit
Tank needs to be adequately supported, you can find examples on the FAQ's & MUST KNOW INFO Page located at top of the website.
Do Not hang by ratchet strap, this is too thin and will not adequately support tank.
Do Not place weight on tank, if you need to stack the tanks you will need a weight bearing shelf between them.

WARRANTY
Manufacturer warranty covers manufacturer defect on manufacturer installed fittings and tank.

INLET & VENT INSTALLATION
Customer will measure and determine where inlet/vent will be placed on Black Waste Tank.
Use correct size hole saw bit in order to drill a hole in the tank and place rubber grommet in hole. Rubber grommet will secure inlet/vent pipe with no adhesives needed.

Included are a few short videos displaying the grommet installation process.