Features & Specifications SuperFlex Roofing Roll
Single-ply membrane that is approximately half of the weight of EPDM
.165 lbs/sq feet compared to EPDM at .29 lbs/sq foot
Will not chalk, fade, or leave streaks down the side of your RV
Brilliant UV performance and is resistant to mold, algae, and fungus
Better puncture resistance than EPDM at .028 Thick
Non-skid surface for better traction. Install roofing with smooth side down, facing glue.
Color is same throughout substrate
Will not shrink or crack (100% solids sealant)
Stretches easier so you can get a perfect, tight fit
Can be easily repaired.
COLOR White
THICKNESS 32mils
Features & Specifications Alpha Systems 8010 Adhesive
8010 is a technically advanced scientific formula of water base adhesive designed for use as a bonding adhesive for single ply roofing membranes.
DESIGNED TO BOND EPDM, PVC, and Hypalon to wood fiberboard, plywood, EPS, any typical polyisocyanurate insulation, gypsum, concrete, etc.
8010 may be applied by spray, roll coating, or by brush.
Grows stronger and adheres more with age.
Remains flexible to compensate for expansion and contraction of the membrane itself.
COLOR White
SOLVENT Water Based
ADHESIVE TYPE Modified Acrylic
COVERAGE 160-200 sq ft/gal (1side @ 8-10 mil)
NET WEIGHT 8.50 lbs/gal
SOLIDS CONTENT 68%
VISCOSITY 10,000-15,000 cps (Brookfield RVF)
8010 may be applied by spray, roll coating, or by brush.
(When using spray application an Aro 650095 4.25 inch air motor with a 30:1 ratio pump @ 80 psi using a 651-500 gun equipped with #651551 quick clean and spray tip #T.C. 1565 with 0.015 orifice or similar equipment is recommended).
For maximum bond strength a two-sided application is recommended.
If one surface is porous, such as plywood or fiberboard, it is acceptable to wet laminate the membrane to the substrate.
If both surfaces are non-porous, such as EPS or ISO apply the adhesive to both surfaces 4 - 5 mils and allow to dry approximately 20 - 30 minutes, depending on conditions.
Adhesive will turn from white to clear when it is dry.
Apply membrane to roof deck and roll or broom down sheet to assure 100% contact area.
DO NOT FREEZE - KEEP OUT OF REACH OF CHILDREN
Features & Specifications Putty Tape
Non-hardening, pliable putty tape.
COLOR Gray
Waterproofs overlapping metal seams.
1/8" high X 3/4" wide - Roll 30 feet long
Features & Specifications Alpha Systems 1021 Self Leveling Sealant
1021 HIGH SOLIDS SEALANT is a one part all weather self-leveling sealant designed and formulated to provide excellent weather resistance.
It features high solids, low V.O.C. content, and no hazardous air pollutants (HAP).
This compound provides good adhesion to a variety of substrates.
This product has good low temperature resistance and will not crack at -40oF.
Typically used in RV applications where a long-term weather tight seal with good ozone and UV resistance are required.
Cured sealant is paintable.
Surfaces should be free of dirt, oil, or other contaminants. A solvent cleaned surface is optimum.
BASE EPDM
SOLVENT