Powder Coated to Resist Rust
Crank Handle Made of Hardened Steel Zinc Plated - One Crank Handle Per Pack
Do Not use an impact to raise or lower any of the jacks we sell it will damage the item.
Drive Screw 3/4" Hex Head Double lead acme threaded drive screw
Mounting Plate Dimensions 9” x 4.5” - Screw Pattern May Vary
Extend Height 30"
Collapsed Height roughly "
Collapsed Length roughly 33" (this includes screw)
Crank Handle Made of Hardened Steel Zinc Plated
INSTALLATION
No instruction booklet
No Mounting Hardware
May be mounted to frame in front or rear by either weld-on or bolt-on.
If the distance between the ground and trailer frame is less than 20” use 24” jacks, not 30” jacks.
2,500lb jacks are best used on pop-ups and small aluminum framed trailers. Larger units will need heavier duty jacks like 5,000lb or 7,500lb capacity jacks.
WARNINGS
Do Not screw these down, screws will work their way loose or be pulled out.
Do Not use an impact to raise or lower any of the jacks we sell it will damage the item.
Do Not use the scissors jack to lift excessive weight or tires off the ground. Jack is made to stabilize your unit, not lift unit off the ground. Vehicle frame and door jamb damage may result.
Do Not use these scissors jack as a tire changing jack.