Low Profile Metal Vent Lid
**12 VOLT POWER ONLY 110/115/220 volt such as in a house or generator will damage the unit**
Multiple Speed Fan 3 Speeds Outward and 2 Speeds Inward
High Velocity air fan system - over 300% more air flow movement
Vortex Fan Speed 188 CFM (188 Cubic Feet Per Minute)
9' Fan Blade
1.8 amps of power required
Removable, Fine Mesh Screen
Manual Crank to open/close lid
Rough Cut-out Opening Dimensions (this is the hole you will need in your roof) 14 ½” X 14 ½”
Galvanized Steel Exterior Mounting Flange Dimensions (sits on the top of your unit) 16 ½” X 16 ½”
WARNING*** Vent Flanges and Lid are VERY SHARP - USE CAUTION when touching ***WARNING
Available Inside Garnish ShroudSizes
1" / 3" / 4" / 5" / 6" Vertical Leg (How far up into your ceiling it goes)
1 ¼” Wide Mounting Flange (trim you see inside on the roof)
Color White
No Mounting Hardware Provided Optional Hardware Kits Available
If upgrading non-powered vent 18 Gauge Wire to 12 volt DC recommended
If testing unit before installing unit must be facing in correct direction (face down like installed in RV) if incorrect direction blade will rub.
DO NOT let the unit or circuit board hang by the wires as you will damage the unit